Second Programming Code entered did not match first Programming Code entered.įirst four digits of new Programming Code match an existing User Code. The User Code matches the first four digits of the existing Programming Code. Second User Code entered did not match first User Code entered. Delete a User Code before adding a new one. There is a delay before unlock after a valid User Code is entered.īlinking red but no codes have been entered.ġ9 User Codes already exist. If keypad does not respond after 30 seconds, then replace battery. Too many incorrect User Codes have been entered. See the Keypad Locks Programming Guide to disable Vacation Mode. User Code entered is not a valid User Code. Then add all needed User Codes back into the lock.
I need to delete a User Code that I don't remember.ĭelete all User Codes. Outside thumbturn does not freely spin after deadbolt is thrown. If needed, restore lock to factory settings. See the Keypad Locks Programming Guide for instructions to enable the Turn Lock feature.Ĭheck front of Keypad Locks Programming Guide or back of keypad assembly for default Programming Code. Ensure the cam and bolt positions are correct, as referenced in the installation instructions.īE365: after pushing Schlage button and rotating thumbturn, the deadbolt does not extend. Your lock has been installed incorrectly and is not secure. I can unlock my deadbolt by simply pushing the Schlage button. Within 10 seconds, press and hold until lights green and the lock beeps.Reconnect the battery and wait until is no longer lit.Customer Service cannot retrieve lost default codes! Do not restore factory settings unless you can locate the default codes. All existing User Codes and current Programming Code will be erased. Programming Guide or the back of the keypad before beginning! Default programming and User Codes will be restored. Locate the default programming and User Codes on the front of the Keypad Locks Open the battery compartment and replace the battery.See Replacing the Battery or Restore Factory Settings for more information. The key cannot be removed from the cylinder while the lock is unlocked. * Rotate the key back to starting position to relock. Rotate the thumbturn back to the horizontal position to re-lock.Įmergency Key Override can be used when the battery is completely dead, or when no valid User Code is known.* No User Code is required to open the door when the lock is in this state. Rotate the inside thumbturn to the vertical position.*.FE595 ONLY: Used to put the lock in a locked or unlocked state.The outside lever can be rotated at any time, but will only retract the latch when the lock is unlocked.The inside lever can be rotated at any time to retract the latch.Used to enter codes for programming and unlocking.Rotate the slot on the mounting plate to the LOCKOUT position.When engaged, a key must be used to unlock the lock. Emergency Lock OverrideĮmergency Lock Override can be used to completely disable the keypad. Rotate the thumbturn 90° toward the hinges.Push the key and cylinder into the thumbturn.Replace the cover.Įmergency Key Override can be used to gain access when the battery is completely dead, when no valid User Code is known or when Emergency Lock Override is engaged.
Re-tuck wires so they will not be crimped.Rotate the thumbturn toward the hinges.Rotate the thumbturn away from the hinges.* If the Turn Lock feature is disabled, a valid User Code must be entered to lock the door. If lighting is low, press the Schlage button to illuminate the keypad before beginning. Used only in emergency situations to unlock the lock.Used to unlock the lock after a valid User Code has been entered, or to lock the lock after the Schlage button has been pressed.See the Keypad Locks Programming Guide for more information.
0 kommentar(er)
